Limit

SCPI Commands

FETCh:EVDO:MEASurement<Instance>:MEValuation:TRACe:CDE:ISIGnal:RRI:LIMit

class Limit

Limit commands group definition. 1 total commands, 0 Sub-groups, 1 group commands

fetch() → List[float]

# SCPI: FETCh:EVDO:MEASurement<instance>:MEValuation:TRACe:CDE:ISIGnal:RRI:LIMit
value: List[float] = driver.multiEval.trace.cde.isignal.rri.limit.fetch()

Return limit check results for the code domain error (CDE) I-Signal and Q-Signal bar graphs. For a physical layer subtype 2 or 3 measurement, the bar graphs contain only RRI results. For a physical layer subtype 0/1 measurement the bar graphs contain also pilot results, see method RsCmwEvdoMeas.MultiEval.Trace.Cde.Qsignal.Pilot.Limit.fetch.

Use RsCmwEvdoMeas.reliability.last_value to read the updated reliability indicator.

return

isig_rri_limit: float The number of results depends on the physical layer subtype (see method RsCmwEvdoMeas.Configure.MultiEval.plSubtype) : SF=15 for subtype 0/1 and SF=31 for subtypes 2 and 3. OK: The result is located within the limits or no limit has been defined/enabled for this result. ULEU (user limit exceeded upper) : An upper limit is violated. The result is located above the limit. ULEL (user limit exceeded lower) : A lower limit is violated. The result is located below the limit. Range: OK | ULEU | ULEL